How To Reset Lts Camera

LTS default countersign for IP cameras, DVRs, or NVRs depends on the model numbers and make. Their
before equipment is already activated and comes with a username and a password.

Meanwhile, the latest models are inactivated and the user sets its own countersign the starting time time the device is connected to the network. If it's a camera connected to the NVR, and so the camera will automatically get the aforementioned password equally the recorder.

LTS Default Password

Username: admin and password: 12345
Username: admin and password: LTS12345
Username: admin and password: admin

If none of those piece of work, and so the default password was changed or you lot're using a new version of LTS devices that come up without any default password. The system prompts y'all to create a password the first fourth dimension y'all run the camera or the NVR.

If you're using an IP camera continued to an NVR and for some reason you desire to access the camera directly via the web browser, and so you should try to use the same password equally the NVR. When cameras get plugged into the NVR, they'll self-activate and go the same password as the recorder.

The default IP address for LTS cameras is 192.0.0.64 and the configuration can be done using the SADP tool which is the Hikvision camera tool (that'due south because the LTS are in fact Hikvision OEM running on customized firmware).

How to reset LTS devices

If you tin can't access your camera or recorder using the default password, then you lot should endeavor to reset them. For LTS cameras the reset is quite like shooting fish in a barrel, inspect or open up the photographic camera and locate the reset push button. Most likely it will be embedded on the motherboard, although some camera's versions have it located at the back.

One time you come across the reset button, power off the camera, then power it on again, and right away press and hold the reset push button for xx seconds. Then release it. The camera volition reboot and information technology will revert to manufactory defaults. Try to apply the default passwords or create a new one. Resetting the camera will erase all the settings, but non the footage on the microSD cards.

To reset an LTS DVR or NVR involves clicking the "Forget Password" on the screen and going through the steps to reset it via the security questions. If y'all tin't do that, then you should export the Password Reset Request via the SADP tool and send the file to your seller. When received, they'll send you back a reset file that you accept to use via the SADP tool. That allows you to create a new password.

Keep in listen, LTS doesn't direct back up the end-users. You should contact your reseller or dealer, not LTS directly. When contacting your seller, ensure yous take the serial number of the device and proof of purchase. In some cases, they may demand to remotely access your unit via a computer to perform the reset procedure.

How to find the IP address of LTS devices

LTS IP cameras, DVRs, or NVRs are in fact Hikvision OEM versions that they sell under their own brands. To locate the IP address, use the SADP tool and have the photographic camera connected to the aforementioned network.

And then, install the SADP tool on the laptop ( download it here ), connect the camera or recorder to the aforementioned router/switch where the laptop is getting the internet. And then simply browse the network via the SADP tool, and all the found devices will be listed over there. Now you lot can alter the IP accost, gateway, subnet masks, etc.